Depending on the calibration method chosen in Step 2 this will complete a full calibration on your display including a greyscale 1D LUT (look-up table) and 3x3 Color Matrix, or a greyscale 1D LUT and a 3D LUT color cube.
Press the AutoCal button to begin the Greyscale and Color Gamut AutoCal process.
Below are some general luminance levels for different viewing environments (Supported levels are 45-250 cd/m^2).
Luminance is a subjective target, you may need to target higher to account for the ambient light in your environment.
Click the Read Continuous button to measure your TV's light output at 100% white and adjust the display’s peak white to the desired luminance.
Using the Brightness control for the monitor, displayed on screen, adjust to your luminance target.
Select the display mode you wish to calibrate, and press Reset Current Mode to prepare the display for calibration.
ASUS MONITOR BRIGHTNESS CONTROL SERIES
To take Pre-Calibration Measurements click the Read Series button to measure the display's grayscale and ColorChecker response.
These will be used to compare your calibration results Step 4 In this step, you'll take readings of your display before the calibration.
Power Function is preconfigured, you may change the power function using the box to the right.
Step 3 In this step, you can configure your calibration targets
On the Find Source dialog, select the Asus - Asus ProArt Monitors.
On the Source Settings tab, click the Find Source button.
For a spectrophotometer, no special selection is required.
On the Meter Settings tab, under the Meter Mode drop-down, for a colorimeter select a meter mode appropriate for the display type you are calibrating.
If your meter is not listed on the Find Meters dialog, just click Search.
On the Find Meters dialog, select your meter if it is listed, then click Search.
Calibrates the monitor using a 1D LUT for grayscale calibration, and a 3x3 matrix for color gamut correction.
Calibrates the monitor using a 1D LUT for grayscale calibration, and a 3D LUT for color gamut correction.
Connect via the method you wish you calibrate with.
On the Find Display dialog, you can choose two methods for calibration.
This can be a Thunderbolt 3 cable or a USB-A to USB-C cable (with the USB-C end plugged into the 90W Thunderbolt 3 port on the back of the monitor
Note: If you're using a Thunderbolt 3 cable for your video connection, no extra cables are needed, If you're using HDMI or DisplayPort for your video connection, you will also need to connect a USB cable between your computer and your monitor.
Step 2 Here you will connect to your Asus Monitor and calibration hardware
Welcome to the Calman Asus Monitor Calibration Workflow, press Start Calibration to begin calibration.
Calman (Ultimate or Studio) Version 5.11.0 or later.